Table of Contents
This tool is used to convert hangingwall/footwall polylines into composite drillholes. (complex coal) A temporary file 9 is generated each run. Every drillhole interval will be assigned the following values: - Seam Dip: calculated from the start/end coordinates of the corresponding polyline segment. - Seam Code: obtained by looking up the model code associated with the MSR material.
Before running the tool, the user can thin or re-densify the polylines in order to create the desired number of intervals.
The resulting drillhole file can be used to interpolate the seam dip into a 3D block model. This information can help you predict the different equipment requirements (eg. dozer vs. backhoe vs. shovel).
Python: 2.5.[4-*] MineSight 3D: 6.[10-*].* MineSight Grail: 6.[10-*].*
February-13-2014 - Official release with MS3D.
The Original Code is em-sdip_polylines_to_composites.py
The Initial Developer of the Original Code is Leica Geosystems. Portions created by Leica Geosystems are Copyright (C) 2014 year. Leica Geosystems. All Rights Reserved.